Answer Hub · Process & timing

Who gets paid from a construction draw?

Reviewed by
Reviewed by RAZE
Last reviewed

Short answer

It depends on the disbursement method in the loan agreement. A lender may pay the borrower, who then pays the builder; issue a check payable jointly to the borrower and the contractor; or have a third party pay contractors and suppliers directly. The lender chooses the method, and the inspection comes first.

The four ways the money moves.

A construction loan does not pay out the construction budget at closing. The undisbursed balance usually sits in a loan-in-process account, and each approved draw request releases part of it. Who receives that money is set by the disbursement method:

  • Direct disbursement. The lender pays the borrower, who then pays the contractors. It is simpler to run and carries a higher risk that funds are used for something else.
  • Two-party check. The check is payable jointly to the borrower and the contractor, so both must endorse it.
  • Voucher control. Contractors submit vouchers for completed work, and each is verified before payment is released.
  • Funding control. A third party manages payments directly to contractors and suppliers.

Where the loan agreement allows it, one loan can use more than one. A lender may pay the borrower on most draws and require a two-party check on a large line.

What has to happen before anyone is paid.

The payee is the last decision. Before it, the lender confirms the work is in place with a draw inspection, collects the lien waivers the loan agreement calls for, and orders a title update. How long that takes is covered in how long it takes to fund a construction draw.

Why it matters for lenders.

An inspection shows what was built. It does not show where the money went afterward. When draw proceeds are used for something other than the funded work, the lender can end up with a paid draw and an unpaid subcontractor, and work in place but unpaid can still produce a lien. The disbursement method is the control for that gap, and each lender sets it as a credit decision under its own loan documents. The disbursement methods guide compares the four and the rule to write before the first advance.

How RAZE handles it.

RAZE documents the work; the lender moves the money. A RAZE report shows percent complete by draw sheet line, with photos that carry GPS coordinates and date and time stamps, so the reviewer can read the amount about to be paid against the work it pays for. RAZE does not disburse, approve, deny or fund draws.

Sources

Primary sources only. Where a figure appears on this page, it comes from one of these.

  1. 1.Construction Lending GlossaryRAZE
  2. 2.Construction Draw Disbursement Methods ComparedRAZE
  3. 3.Construction Loan Lien WaiversRAZE

See the workflow behind the answer.

RAZE standardizes how draw inspections are ordered, dispatched, captured and delivered, inside the loan administration workflow a lender already runs.

Get Started