Answer Hub · Audit & compliance
What insurance does a lender check before a construction draw?
- Reviewed by
- Reviewed by RAZE
- Last reviewed
Short answer
Lenders confirm the certificate of insurance, the coverage amount against the completed value, the mortgagee clause and the policy term before each draw. Lenders require builder's risk insurance, named as mortgagee, before the first draw. Each lender sets its own requirements. This is not insurance advice.
The policy on the structure.
Builder's risk insurance is property coverage protecting a structure under construction against fire, wind, theft and vandalism until completion. Lenders require it, named as mortgagee, before the first draw. The builder's risk insurance page covers what the policy leaves out.
The documents a lender reads.
Three terms come up on the lender's side of the file:
- Certificate of insurance (COI). The document evidencing a party's coverage, limits and effective dates. Lenders collect and track it.
- Mortgagee clause. The policy provision protecting the lender's interest and requiring notice before cancellation.
- Loss payee. The party designated to receive insurance proceeds, typically the lender for property coverage.
The contractor's coverage.
General liability insurance is coverage for third-party bodily injury and property damage arising from the contractor's operations. Workers' compensation is statutorily required coverage for employee injuries on the job; lenders verify contractors carry it.
The dates.
Lenders extend the policy when the schedule slips past its expiration. A vacancy clause is a policy provision reducing or voiding coverage if the property is vacant beyond a stated period, which is a risk on stalled projects.
Why it matters for lenders.
The inspection documents what exists on the site. The insurance is a separate page in the file, and each lender sets its own requirements for it. This page recommends no coverage, limit or carrier and is not insurance advice. The insurance guide covers when a lender looks at each document.
How RAZE handles it.
RAZE documents the work; the lender decides what to fund. A RAZE report shows percent complete by draw sheet line, with photos that carry GPS coordinates and date and time stamps. A draw inspection is not an insurance review, and RAZE does not review policies. RAZE does not approve, deny or fund draws.
Sources
Primary sources only. Where a figure appears on this page, it comes from one of these.
See the workflow behind the answer.
RAZE standardizes how draw inspections are ordered, dispatched, captured and delivered, inside the loan administration workflow a lender already runs.
Get Started